How to Measure Scope Ring Height?

• Posted by Jere Lex 6 hours ago Filed in Other #shotelex riflescope  #scope ring  7 views
  click to rate

  Choosing the right scope ring height is crucial for achieving a comfortable shooting position, proper eye alignment, and optimal scope performance. Whether you're mounting a scope on a hunting rifle or setting up a precision rifle for long-range shooting, understanding how to measure scope ring height correctly can make all the difference.

  What Is Scope Ring Height?

  Scope ring height refers to the vertical distance between the top of the rifle's mounting rail (typically a Picatinny or Weaver base) and the center of the scope tube. This measurement determines how high the scope sits above the barrel, which affects eye relief, cheek weld, and even scope clearance.

  Scope rings are usually categorized into three common heights:

  • Low – For smaller objective lenses (e.g., 32mm or less)

  • Medium – Suitable for 40–42mm objective lenses

  • High – Needed for large objective lenses (e.g., 50mm+)

  How to Measure Scope Ring Height

  Here’s a step-by-step guide to help you accurately measure scope ring height:

  1. Know Your Scope’s Key Dimensions

  Start by identifying two important specifications of your scope:

  • Objective lens diameter (e.g., 50mm)

  • Main tube diameter (either 1 inch / 25.4mm, 30mm, or 34mm)

  The objective bell is typically larger than the tube, and this size will determine how much clearance is needed above the barrel.

  2. Calculate Half of the Objective Lens Diameter

  Since you only need enough clearance from the center of the tube to the bottom of the scope’s objective bell, divide the objective lens size by two.

  Example:

  • 50mm objective lens ÷ 2 = 25mm

  • Tip: Some scopes have built-in housing or sunshades that make the bell larger than the lens size. Always measure the outer diameter if possible.

  3. Account for Scope Tube Height

  Add half the tube diameter to the result. For a 30mm scope:

  • 30mm ÷ 2 = 15mm

  So, total height from the mounting base to the center of the scope would be:

  • 25mm (objective bell half) + 15mm (tube half) = 40mm

  4. Measure the Scope Ring Height

  Now check the manufacturer's specifications or measure manually from:

  • The base of the scope ring (the part touching the mounting rail)

  • To the bottom of the ring saddle (where the scope tube sits)

  That vertical distance should be equal to or slightly more than the number you calculated in step 3 to ensure proper clearance.

  Helpful Tools

  • Caliper or ruler – For measuring your scope’s actual dimensions

  • Scope ring height chart – Many manufacturers like Vortex, Leupold, and Warne provide charts showing ring heights in millimeters or inches

  • Online calculators – Some shooting forums and websites offer scope height calculators

  Common Mistakes to Avoid

  • Choosing rings that are too high – Can cause poor cheek weld and instability

  • Too low – May lead to the scope touching the barrel or bolt handle

  • Ignoring rail height – Some rifles have high or low rail profiles, which affects total scope height

  Final Thoughts

  Measuring scope ring height isn’t just a technical detail — it’s a key step in building a comfortable and accurate shooting system. Always double-check your measurements, consider your rifle’s geometry, and when in doubt, consult the scope or ring manufacturer.